Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kj
Most generator manufacturers have a requirement of the sets
being regularly serviced. The are also different codes
(e.g. fire codes) which require the regular servicing. The
type of service is usually designated as A to D.
An A service is usually a check of the generator to make
sure all systems are functioning correctly.
This steps up through oil and filter change to replacement
of consumable parts at D.
Consumable parts are the parts such and belts, hoses,
coolant pump, injectors, etc.
Each of these services are set by a time period or hours of
operation similar to the servicing of a car.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
for a 400kv t/m line with 10 ampere current will corona occur?
would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?
hi if anybody got model questions for cpcl Grade'A' electrical engineer position.send it to my mail please krishkumar22@gmail.com
What is the difference between Delta & Wye windings?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
describe the Tranformer testing procedure
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
Testing report of Earthing of 3.15 MVa PTR.
hello friends this is krunal here.. i have applied for he officer train in hpcl electrical stream.. any one who have applied before for electrical stream please help me out.. post ur reply to my mail id: krunal_airforce@yahoo.com.. any tips, old questions for paper or any help will do.. plz help me.. your faithfully, Krunal Darji
what is electrical machines
checking procedure of capacitor based motors.used in fans etc?
