Answer / santosh bangar

oil sample from top which is heated..and bottom oil which is
cool ..so if we take sample from bottom then that have more
BDV than sample from top.. but practically there is minor
difference .

Answer / r.k.pandey

Depends on density,bottom oil sample have more density than up per side of area transformer.if every where inside the transformer temperature is the same. no more difference.

Is there any type of starter for DC motor other than two point,Three point and Four point starters?

0 Answers  

---

What is the effect of pi controller on the system performance?

0 Answers  

---

why we step down voltage level from 33kv to 11kv and 11kv to 415v.Instead we can step down voltage from 33kv to 415v directly using single transformer?

3 Answers  

---

what is the highest transmission voltage in india???

49 Answers   Bhel, EIPL, Engineering, Jindal,

---

What should be the overcurrent, instantaneous overcurrent, short cicuit current settings (i.e. how many times of motor full load and what is the time duration) for a motor?

1 Answers  

---

---

BRIEFELY EXPLAIN MEGGAR PRINCIPLE

2 Answers  

---

why AC cannot to be stored and DC cannot be transmitted?

11 Answers   IBM,

---

A 11000/415V distribution transformer is fed 415V upon it's LT side,Do I get 11000V upon it's Primary side ?

7 Answers  

---

Why selected cable colour red yellow and blue in 3 phase Electrical system?

9 Answers   Crompton Greaves, Essar, Gridco,

---

if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required

0 Answers  

---

WHY WE USE SIEMENS plC

3 Answers  

---

wat is the function of an inductor? examples.....

4 Answers  

---