which transfofrmer oil break down voltage strength get will
be more if oil sample taken from bottom of tank or oil
sample taken from top of the transfomer tank.
- 2 Answers
- 4433 Views
- NPCIL, I also Faced
- E-Mail Answers
Answer Posted / r.k.pandey
Depends on density,bottom oil sample have more density than up per side of area transformer.if every where inside the transformer temperature is the same. no more difference.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
A cotter joint is generally used to transmit
What is electrical diversity factor in electrical installations?
why -48 volts dc used in telecommucation
all details of DG UPS HVAC
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?
What is a surge supressor why its is used in synchronous generators
How is the gain affected by the introduction of feedback in a control system.
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What is meant by short-pitched winding?
how to estimate wiring ins roughing ins. and boxes
What are protections for dty type transformers
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
