Interested to Buy Any Domain ? << Click Here >> for more details...
I want condensate pots vent position erection of flow
transmitter ?
- 1 Answers
- 4180 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
A 'vent' or 'fill port' is installed at the top of a
condensate pot, facing upwards, so the water can be poured
through the vent's opening to fill the impulse tubing/piping
and the condensate pot.
Carl Ellis
Measure First
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is 24vdc live and dry supply
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
Name different parts of a pressure gauge.
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
How many interlocks at turbine? Plz explain briefly
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
all types of liquid analyzer principle with drawing?
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
why would you like to join our company
How to fix back the valve actuator stem
detail of mass flow meter pricipal
