Answer / engr. kashif

All connections are made in parallel. e.g. lights, fans, socket outlets all are arranged in parallel. However the control switch of any device like a fan or light is put in parallel to that.
the wiring starts by dividing the main connection to a number of points same as the number of rooms in ur residence. Each goes through a Circuit breaker, and then to the room where the line is further divided depending on the number of appliances, sockets, power plugs. Each line then goes to the respective point then connects to the load and at the other side of the load is the neutral which is common through the residence.

What happened to installed high capacity conductor for smaller current rating?

1 Answers  

---

What is the difference between voltage and emf ?

3 Answers   DRDO,

---

Difference between low impedance and high impedance Restricted Earth Fault

0 Answers  

---

Lt motor sfu flashing reasons?

0 Answers   NDFL,

---

How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.

0 Answers   Grasim,

---

Why in India distribution transformer are connected in Dyn11 when we know capacity of v-v connection can be increased by adding only a single transformer?

1 Answers   CSPL,

---

WHAT IS FORMULA TO KNOW TO BACKUP TIME OF POWER PLANT 48V/50AMP DELTA POWER PLANT

1 Answers  

---

What is the full form of GSL wire

8 Answers   Bhel, GSL,

---

What is the difference between Delta & Wye windings?

0 Answers  

---

10 Mtr Hight of Lighting Arrestar how much area coverd??

0 Answers   OmniActive,

---

How big (size) can the tertiary winding be in transformer? Can we load the tertiary winding, if yes then how much we can load it?

1 Answers  

---

What is Plank's Law?

0 Answers   Godrej,

---