Answer Posted / engr. kashif

All connections are made in parallel. e.g. lights, fans, socket outlets all are arranged in parallel. However the control switch of any device like a fan or light is put in parallel to that.
the wiring starts by dividing the main connection to a number of points same as the number of rooms in ur residence. Each goes through a Circuit breaker, and then to the room where the line is further divided depending on the number of appliances, sockets, power plugs. Each line then goes to the respective point then connects to the load and at the other side of the load is the neutral which is common through the residence.

are there rmu for 3 transformer?

1881

---

what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..

2106

---

What is stacking factor? What is its approximate value?

1442

---

Define liftable weight of a transformer? Does the total weight of transformer include oil weight?

2495

---

What is the percentage loss for aluminium wire for HT line more than 11KVa

2128

---

Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.

1786

---

what is Fault level? why it is calculated? how will u decide same for our plant?

2059

---

How to calculate the heat load for a electrical room

3085

---

how we calculate the dick for a pole?

2185

---

how can we select the appropriate VCB ?

2321

---

How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.

2326

---

how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com

2914

---

What are the types of power in electrical power?

1214

---

what is the need of starter in tube light and what type of starter is used in that?

2026

---

can i connect the two phases of scott connected transformer,if not why?

1975

---