Interested to Buy Any Domain ? << Click Here >> for more details...
why in an industry; machine having rated 200 h.p stopped
after power factor is maintained above 0.97 lag by control
panel in view-of energy saving
- 0 Answers
- 2132 Views
- HCL, I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
in 3 phase induction motor resistance value is how much
which have higher efficiency transformer or induction moter
What is applied voltage for meggering a 6600V HT cable
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
What is acsr cable and where we use it?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Earth Resistivity
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
What safety followup during kWh meter isolation
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
