Answer / sudhakar g

Due to the FORM FACTOR we can saw all the voltages in
11,22,33,66KV
suppose 10kv*Form factor
10Kv*1.11=11kv

In generating stations which we generate current or voltage if it is voltage then how it will convert to current and power?

2 Answers   NIT,

---

Why the earth to phase voltage is high 250 compare to other two phases

0 Answers  

---

How Grading Rings & spacers in transmission lines works?working principle?

1 Answers  

---

my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.

0 Answers  

---

How capacitor improves pf

0 Answers  

---

What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?

0 Answers  

---

Draw SLD feeding from the SS up to distribution board of the load, calculate cable size, breaker sizes, and meter for the following case: Ground Floor: electric room, pump room, 5 shops, each is 15 KW First Floor: 5 shops, each is 15 KW Second Floor: showroom 30 KW Service Loads: water pump 3 KW (3ph) , fire pump 3 KW (3ph), and one DB service 12 KW (3ph).

0 Answers   FEWA, HMK,

---

Why Diffrential and Ref relays are used together although Diffrential relay can protect Pri and Sec of Transformer

1 Answers   Qatar Gas,

---

What is the difference between Earthing & grounding

4 Answers  

---

IF we have 500kva transformer 11.0/0.415V, 50Hz. How to calculate the current on HT & LT side, how can we consider for its breaker (HT & LT both)? You are requested to solve the question herewith.

3 Answers   Bhutan Power Corporation,

---

what is the difference between STAR and DELTA connection and application wise how it can be utilizedd ???

1 Answers  

---

WHEN SINGLE PHASE SUPPLY AS 220V, WHY THE 3 PHASE- 4 WIRE MEASURED AS 440 VOLTS INSTEAD OF 660 VOLTS (220 VOLTS PER PHASE i.e 220x3 = 660 volts ).

1 Answers  

---