how to calculate diesel consumption of a D.G.Set?
Answers were Sorted based on User's Feedback
Answer / k.k dash
dg set consumes at 10% load =7 ltr deisel for 380 kva cummins engines
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / sudhakar g
We can not calculate the diesel comsumption...depending upon
load it will conume the diesel...suppose the 1500kva D.G is
running and the load is 1000kw means it will consume 150-200
liters per hour....
Is This Answer Correct ? | 4 Yes | 4 No |
Answer / darcl facility
Suppose A gensets is 500 Kva and load is running 50 % on the Gen Sets.
Now We can Canclulate the following-
Max Load will be- 500*1.39= 695
50 % Load will be= 685*.5= 347 A.
Now Calculate the Kwh = 1.732*415*347*.8= 200 Unit Appx per Hours.
As we know the Average maximum UPL is 3.4 to 3.8 Unit.
Load is apprimate 50 percenatge so Divide the total unit by 3
Results is = 200/3= Apprximate 65 Liter per hours.
Is This Answer Correct ? | 1 Yes | 3 No |
I have 10 amp MCB for my air conditioner of 1.5 ton capacity. When I connect the ac direct it is started running but when connected through stabliser the Mcb Get trip and air conditioner couldn't start.please confirm whether Mcb is required to be upgraded to 20 amp. There is no fault in ac and the stabliser. Please advice the reason of tripping the mcb when connected through the stabliser.
50 electric bulbs are connected across supply of 220 volts. After one bulb is fused remaining 49 bulbs are again connected to same supply. which case will have more illumination & WHY????????
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Is current shock due to voltage or current? pls answer
I have two power supply.a)govt. power b)Captive power.3 phase load connected inside factory.when source change govt. source to captive some motor rotate reverse. Is phase sequence changes when if off & on?If I off generator & on it again is it possible to get changed phase sequence??
what is the working of ups.
no EB power DG is not starting?
what is power factor when in view of a lineman
what is the significance of tan&delta and how it performed in power transformer
1.how many types of relays? 2.difference between ATS& STS?
what is the general Classification of Generators
please send me previose rrb junior engineer qustion papers