Answer / kunal

first of all open the two nos screw than check interlock if
bypassed, than PULL the card.

so simple.

Answer / muzaffar

If the Card is redundant then there will be no problem to change the failure card. if it's non-redundant cards then please follow the Kunal instructions.

Answer / faiyaz ahmad

DCS card can change very easily because the DCS system would be redundant means each Nodes having a Stand by That is why if you want change DCS card you can when you will change the card another will come online by its self all are in automation system.

why we use casced loop

6 Answers  

---

What is the difference between working pressure and calibration pressure of a control valve

0 Answers  

---

How u measure the massflow in orifice flow measurement techniques

0 Answers   Johnson Matthey,

---

Calibration procedure for electro magnetic flow meter

0 Answers  

---

why use to 250 ohm for hart protocol and why hart communicator not communicate without 250 ohm 

4 Answers   OMV,

---

Intools training

1 Answers  

---

what is coriolis principle for mass flowmeter?

5 Answers   ABB,

---

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers  

---

how to use level tranasmitter in closed tank application.?

3 Answers   Dalkia,

---

hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?

0 Answers  

---

what is DCS and SCADA?

2 Answers   APL,

---

i am working in the automation company...i want to just know how actully pid control valves are tune????...

1 Answers  

---