a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of
0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy
of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the
accuracy ratio? is this ratio acceptable?

Question Posted / markwilcon

2 Answers
4752 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It ..

Answer / sreedhar

It Can Be Calibrated. The Accuracy Ratio Is 1:4 It Is Acceptable

Is This Answer Correct ?

0 Yes

1 No

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It ..

Answer / markwilcon

anyone able to help?

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Instrumentation Interview Questions

how to measure low temperature(<100 dec celsisus) with non condact sensor

2 Answers

What is sensitivity of K type thermocouple? Is polarity important in thermocouple connections?

3 Answers Honeywell,

how to relay switch sense the fault?

0 Answers ME,

how to calibrate absolute pressure transmitter

7 Answers ABB,

what is diff between sensors and transducers.explain with ex?

15 Answers

what r all the type of viberation measurement measuring in turbin? what's the output of viberation sensor?

2 Answers

NAME ANY TWO ELASTIC PRESURE SENSOR?

2 Answers DVC,

how to design orifice plate?what is the equation?

0 Answers REL,

The DCS stand for________________________. it is composed of the following major components: a:______________ b:______________ c:______________ d:______________

2 Answers

List three types Level Gauges with their working principles

0 Answers ABB,

hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com

0 Answers

(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.

0 Answers ADMA OPCO,

For more Instrumentation Interview Questions Click Here