How to convert Differential pressure to flow in TPH

0 Answers   Chettinad, ELCO,

---

what is fire and gas system?

2 Answers   Andhra Petrochemicals Limited,

---

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

why use to 250 ohm for hart protocol and why hart communicator not communicate without 250 ohm 

4 Answers   OMV,

---

how to control motor load with rpm or vfd

1 Answers  

---

how can we calibrate the differential pressure transmitter by using HART communicator

8 Answers   Hindalco,

---

Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor

0 Answers   CCIE,

---

Galvanizing.

0 Answers   CCIE,

---

Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?

0 Answers  

---

HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.

0 Answers   Reliance,

---

What happens if the Displacer has fallen or has a hole in it?

1 Answers   CCIE,

---

what is function of switch, and how is it work, explain with difination

0 Answers   Bapco Bahrain Petroleum Company,

---