Why we have use 3 & 1/2 core cable use for general electrical supply arrange

Why we have use 3 & 1/2 core cable use for general electrical supply arrangement

Question Posted / achuythimanshu

1 Answers
4024 Views
I also Faced
E-Mail Answers

Why we have use 3 & 1/2 core cable use for general electrical supply arrangement..

1/2 CORE USED FOR NEUTRAL CONNECTION. IF ELECTRICAL LOAD IS
BALANCED THEN NO LOAD WILL BE ON NEUTRAL, IF LOAD IS
UNBALANCED THEN UNBALANCED LOAD WILL GOES THROUGH
NEUTRAL.SO FIRST WE SEE THAT LOAD IS BALANCED IN PHASES
THEN IN THIS CONDITION NO CURRENT WILL FLOW THROUGH
NEUTRAL,SO NOT REQUIRED FULL CORE.

Is This Answer Correct ?

5 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why transmission line towers are longer than communication line towers?

3 Answers

How to calculate the multiplying factor for energy meter with ct ratio given

0 Answers

how to connect generators in parallel and what are the required equipment to do so?

2 Answers MSEB,

what are symmetrical and non symmetrical components in electrical installation.

0 Answers

How to calculate Battery back up time for a 400 AH Battery bank having a load of 20 Amps and charging time required to fully charge this battery bank?

2 Answers

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers

How to setting the volume of RTCC panel AVR (11kv) controller

0 Answers CNF Automotive India,

th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.

0 Answers HMC,

What is best method of Calculating Short Circuit current in power system network.

1 Answers

What is OLTC in transformers and what is its function?

4 Answers

What is instrumental error?

0 Answers

Why you want to join non technical field when you are an engineer?

0 Answers

For more Electrical Engineering Interview Questions Click Here