Answer / dipak thumar

You should mention the rating of DG, no. and types of
battery used. etc...

Answer / v.venkata ramana

power drawn to the system 167.5 amps

Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?

0 Answers  

---

In a 3 phase induction motor(without connecting supply) if we rotate its rotor by hand and check resistance of stator winding at motor terminal box its resistance varies why ??

3 Answers   Jindal,

---

What is open loop and control loop systems?

0 Answers  

---

i want to estabilish an loss energy storage system,such that it can store electricity lost during the transmission of electricity in conductor,so that this system stores energy lost during transmission and supply it to street lights during night

2 Answers  

---

what is the difference between LPF and UPF wattmeter and where it is used.

7 Answers  

---

what ll happen if neutral is not shorted with phases while doing transformer short circuit test & what ll happen if neutral is connected to ground?

1 Answers  

---

is there any phase difference occurs while primary and secondary side mutual induction occurs?

0 Answers  

---

How can you calculate in detail the VA burden of current transformer used for Restricted earth fault protection? Please understand that the CT required here is Class PX or X. Also please show the calculations for knee point vtg, stabilizing resistor, magnetising current.

3 Answers  

---

What is the multiplying factor if line ct ratio is 1000/1 and meter ct ratio is -/5 ?

1 Answers  

---

How to calculate earth wire load by formula

0 Answers   Caparo,

---

What is the resistance to be connected for supplying the load of 20mV,1kohm from 20mV supply using rectifier.

1 Answers   Anna University,

---

Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?

0 Answers  

---