Answer / tarique

to analylize the quality and purity of fluid and material

when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

2 Answers  

---

Hello-I know this not an engineering question,I am working in gulf & i want to do correspondence diploma in instrumentation,can any one give me the address of any university in which this courses are available.

2 Answers  

---

how can loop single 4-20 ma to two isolation amplifier? i mean i have two isolation amplifier with 4-20 ma input and 1-5 v output.can i done series connection ?

1 Answers  

---

Can someone give a detailed chart on the temperature ranges which can be measured by various temperature sensors.

3 Answers  

---

I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

0 Answers  

---

Explain the usage of the PLC system?

3 Answers  

---

What is the load line in control valve?

1 Answers   IFFCO,

---

How the sizing of the analog signal cable is calculate?

0 Answers   Reliance,

---

What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?

0 Answers  

---

i am confusing about differential pressure transmitter as i seen so many DPTs in different ranges how can we calculate level and flow with mmh20 plz tel me

1 Answers  

---

I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.

0 Answers  

---

why the output sugnal is 4-20 ma and not 4-25 ma?

5 Answers  

---