Answer / ahsan raza

Reset: When a controller is entered in an infinite loop i.e
being hanged then we need to reset the device in order to
release from the infinite loop.
Initialization: To start the device right from the initial
variable is termed as initialization

What is the deffernce bet. Instrumentation and Electrical Enginerring?

1 Answers  

---

Explain PID, ON/OFF, Controls

0 Answers   CCIE, Gulf Engineering,

---

Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...

0 Answers   Adgas, GAIL, Oil India, ONGC,

---

Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?

0 Answers  

---

What different types of problems do occur while doing the loop checking? and please explain in detail or mail me at kadam.aniket143@gmail.com

1 Answers   Operational Energy Group, Process Control Technologies,

---

should I use Hydrostatic Pressure Transmitter for measurement of DENSITY of filled tank ? If YES then please explain how.

2 Answers   HPCL,

---

how bolometer is used in temperature measurement ??

1 Answers  

---

for commissioning the DPT and Flow Transmitter , what kind of necessary activities we have to check and do? specially that orifice flange valve[ isolation valve}

1 Answers   L&T,

---

what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?

0 Answers  

---

HI FRIENDS IHAVE QUESTION 1.WHAT IS PARTIALSTROKE TEST?WHY IT IS USED ON ESD ON OFF VALVES?

3 Answers   KNPC, Rotork,

---

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers  

---

how to trim the pressure transmitter ?

2 Answers  

---