Answer / kranti1986

The method used to calibrate a magnetic flow transmitter is Dry Calibration, in which we use a calibrator(usually called as Simulator, provided by the vendor)connected to the transmitter and increase the knob in steps.
If there is any error we can adjust

Witch type cable use for rtd ,why?

2 Answers   Sugar Factory,

---

how to wire from pressure transmitter to marshalling panel and panel to controller and controller to dcs plz give the answer with example .

2 Answers  

---

What is the Working principle of Dozing valve?

0 Answers   Shree Cement,

---

working principle of lvdt?

2 Answers  

---

where we are used split range control

1 Answers   Borouge,

---

---

What should we do when Fisher Fieldvue DVC2000 give some out put air at 4mA bt at that i need no out put

1 Answers  

---

What is open loop and close loop?

4 Answers   L&T, Pearl Distillery,

---

䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ

0 Answers  

---

What is the working principle of oxygen analyzers(zirconium oxide type) used in CFBC boilers?

3 Answers   Bajaj, Kohinoor, Wartsila,

---

if a tank is contaning oil and water than how can we measure the oil and water level seperately

3 Answers  

---

Hi friends, from Aug 4th onwards iam getting spikes for analog inputs in our DCS for a period of 800ms. I throughly checked every thing, finally i found that the DI, DO's from MCC panels shields are terminated in the Signal Earth where Analog Input signals shields are terminated. Is there any problem with this type of termination?. i checked the induction voltage from MCC and getting around 25VAC, please suggest me in this concern. Our plant is 8months old only. DCS is Siemens Make Simatic PCS7, and the transmitters are Yokogawa make.

1 Answers  

---

What should be the stanchan Height for installation of Smoke detector & toxic gas detector in field,according to qatar standard

2 Answers  

---