Answer / carl_ellis

A Load line shows the valve's pressure drop at different
flow rates. When graphed, the flow rate is typically on the
y axis, the pressure drop on the x axis.

Typically the load line starts high at low flow (high DP)
and decreases as the flow increases to a low DP when the
valve is wide open.

Carl Ellis
Measure First

Hi..i am B.E. (elect.&comm.)..i m workini in a bio mass power plant as inst. Engg. I want 2 know about growth in big power plant sector..is this field is good 4 me ..i m electronics engg..? Plz plz reply..

2 Answers   Reliance,

---

what is meant by turn down ratio?

3 Answers   Avant Garde,

---

Give me best instrumentation Books name..Ple...

6 Answers  

---

When can a bypass not used on a positioner?

1 Answers   CCIE,

---

how to calibrate differential pressure switch

2 Answers  

---

on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon

0 Answers  

---

what is diff b/w neutron and ground?

3 Answers  

---

Control valve Flow characteristic. How the equal percentege curve form?

5 Answers  

---

1. What means HART communicator / where it is used / how to use it? 2. Types of Thermocouples and its temperature ranges / output of thermocouple? 3. Types of RTDs and its temperature ranges / output of RTD? 4. Idea about Temperature Transmitters? 5. Difference between Analog and Digital signals? 6. Difference between “2 wire” and “4 wire” system / instruments? 7. Difference between “Potential” and “Potential free” contact? 8. Types of flow meters / transmitters? 9. Types of level transmitters? 10. Difference between “Power/Control” cable and “Instrument” cable? 11. What means “shield” and “screen” in cables / how it is useful? 12. Draw a schematic of closed loop circuit of flow / level / pressure / temperature? 13. Idea about calibration of Control valve / positioned / I/P? 14. How to bypass a digital/analog signal in PLC/DCS by hardwire and software?

6 Answers   JSL,

---

Can 2 transmitters be connected to Integral orifice meter taps? Does an integral orifice comes with 2 set of taps?

1 Answers  

---

Consider a level troll. i am getting a correct value in 4mA and 20mA. the value in the middle(30 to 60%)is disturbed and i am not getting the appropriate value. what is the solution to normalize the level and to get the correct value..

2 Answers   KNPC,

---

Watt is Wrms define rms?

2 Answers  

---