We have two Al.busbars each of size 125mm*10 mm connected in
parallel.To increase the current rating ,can we connect
third busbar of size 100mm*10mm in parallel to existing two
busbars?In my opinion ,if we connect busbars of different
sizes in parallel,then the busbar of lowest size will take
much current.So this type of paralleling should be avoided
.Am I correct?
- 1 Answers
- 2823 Views
- PDP Steel, I also Faced
- E-Mail Answers
Answer / vineet kumar srivastava
in this parallel operation every bus bar will take equal
current so if this rating is equal to running current (after
divided same load), can provide it.
| Is This Answer Correct ? | 0 Yes | 1 No |
why the carbon brushes are broken in srim while the motor runningtime
Why in USA supply voltage parameters(230V,60Hz)are different,is there any advantage please brief.
how we are desining 63.5 ohm resistor for NGR of alternator?
What is quadrantal symmetry?
How many types of Transformer testing..
how does a shunt reactor maintains the bus voltage???
working principle of AC Servo Motor with its construction
V.c.b and a.c.b difference
opkinson's test
can we transmit power with out cable if it is possible how it is possible.
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
why fan consume constant power even when we increase or decrease its circuit resistance through speed regulator???
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
