Interested to Buy Any Domain ? << Click Here >> for more details...
We have two Al.busbars each of size 125mm*10 mm connected in
parallel.To increase the current rating ,can we connect
third busbar of size 100mm*10mm in parallel to existing two
busbars?In my opinion ,if we connect busbars of different
sizes in parallel,then the busbar of lowest size will take
much current.So this type of paralleling should be avoided
.Am I correct?
- 1 Answers
- 3475 Views
- PDP Steel, I also Faced
- E-Mail Answers
Answer Posted / vineet kumar srivastava
in this parallel operation every bus bar will take equal
current so if this rating is equal to running current (after
divided same load), can provide it.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
1. What is the exact formula for one weber? for example,(one ampere = one coulomb electron of electrons crossing a point of conductor at one second. i.e, 1A=1Q/1sec)
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
How to measure the earth resistance value in a concrete pavement(flood light area)?
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
rajha power sector details
What are the advantages & disadvantages of a group electrive drive?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
State the points to be considered for selecting a particular type wiring.
do we use neutral grounding for resistive balanced load? if we use what happen?
What is George phenomena to start the synchronus machine?
how to calculate the earth fault current
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
