Answer / manoj

Vibration sensor based on 1)fixed pt sendor 2)variable sensor
fixed sensor -by manual scale fixed near to machine
valiable sensor-1)seismic transdusar 2)clectromechanical
tranducer 3)capacitive rtnasdusor 4)proximity type
5)photodiode type
proximity type -it is eddy current type .when we are giving
supply -24 v.sensor develop Rf field.in machine eddy current
develop ,due to current loss of power in Rf field so we get
in o/t less voltage depend on gap voltage

Answer / manoj

If you are asking about non contact type sensors, both vibration and speed are measured by proximity sensors only. In vibration, the displacement of the measured body from a set point is calculated.
speed is measured by the number of times the voltage drops while a notch(on the body of the rotor) crosses the sensor, which is done by Keyphasor(which is also a proximity sensor).

Answer / harikumar

Axial ,Radial & Keyphaser
Proximior is a tranducer and a RF device that arrives from
probe.It convert the probe gap information in to a
proportioally linear output voltage.

what is Micro-switch and where it is used......?

7 Answers  

---

what is the difference between profibus and controlnet networking.

0 Answers   HZL,

---

Isometric drawings are generated during _________________ phase of a project

0 Answers  

---

difference between accuracy and precision

6 Answers   Honeywell, ONGC,

---

Definition of level

3 Answers  

---

---

what is DCS?

24 Answers   Reliance, SWCC,

---

i am having information technology branh ....... can i prepare for psu exam

0 Answers  

---

What is Electrical Runout & Mechanical Runout in Vibration measurement.

1 Answers  

---

1. How many output signals do wew have in process control? 2. Could you write down the names of the pre-commissioning and commissioning stage test instruments and explain them (more than 5 items)? 3. What is the first step to commission a transmitter on service? 4. What is RTD? 5. Find the output value in MA of a temperature transmitter (RTD Type) at 120degree celius? 6. What is the O/P signal of a pneumatic transmitter? 7. What is the O/P signal of an elctronic transmitter? 8. What is the close loop and open loon?

4 Answers  

---

how many types of thermocouple cable are? give the name of each type.

1 Answers   Fabco,

---

steps for installing orifice plate?

0 Answers   Bhushan Power Steel,

---

What are advantages and disadvantage of the ac supply load cell?

0 Answers  

---