Interested to Buy Any Domain ? << Click Here >> for more details...
what are the sensor types of vibration&speed?n what is
proximity sensor?
- 3 Answers
- 7278 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj
If you are asking about non contact type sensors, both vibration and speed are measured by proximity sensors only. In vibration, the displacement of the measured body from a set point is calculated.
speed is measured by the number of times the voltage drops while a notch(on the body of the rotor) crosses the sensor, which is done by Keyphasor(which is also a proximity sensor).
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What is Positive Calibration and Negative Calibration?
Draw symbols of the following :
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
key exchanges in wpa,wpa2,tls
what is the difference between attemperator and desuperheater ?
why we are not using the turbine flow meter in the steam service?
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
NSV type probe stands for
What is 3 selection available when configure the burnout protection for controller
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
how do u calibrate the vacuum transmitter if it shows more reading
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
