Hi at present i m wrking with tire industry as a manager having gud ctc. Nw I am

Hi at present i m wrking with tire industry as a manager having gud ctc. Nw I am selected for 1 of the best chemical industry but my ctc is lower than current n also i hv 2 compromize vit post as post is also lower. I hv 6 yrs of exp in various type of industry. Should i join chemical industry as there ar lot of gud instrument than tire? Financialy i can manage 4 more 2 yrs. Bt during wrking vit tire industry i found there is very less instrument n feel that opportunity is less. Pl ans quickly. I have less time to decide.

Question Posted / rame

1 Answers
3602 Views
I also Faced
E-Mail Answers

Hi at present i m wrking with tire industry as a manager having gud ctc. Nw I am selected for 1 of t..

Answer / elangovan

Please Join chemical industry.....6 years of experince in
tire industry cannot compared to chemaicl indutry in
instrumentation filed...continue to be in the chemial for a
long time..then you cna try for DOW chemicals ..or any
other bigger indutry in india or abroad..oppurtunites are
more in chemical industry for instrumentation enigneers....

Is This Answer Correct ?

8 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

what is the path to communicate from profi to ofc.what is the means of communication.what is multi cire cable in ofc.

1 Answers

when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

2 Answers

can u briefly explain aboutan aryton shunt multirange DC ammeter?

0 Answers

how to write the program for single push button by using ladder diagram

22 Answers DigiTech,

why we are using -24 vdc in plc?

1 Answers CGL,

What is the difference between sdv and bdv ?

1 Answers

How to check electrical health of Vibration probe?

1 Answers QAFCO,

If we interchange HP and LP tapping in drum level measurement and reverse LRV & URV correspondingly.What is the difference between the normal tapping(HP,LP) and reversed tapping(LP,HP)?

2 Answers

WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN

0 Answers

how to calculate control valve bonnet size?? or how to select its material?

0 Answers Jacobs,

Give me a simple formula to calculate the bore of orifice plate with datas avilable instead of BS 1040.I want to calculate the approximate bore size only.

0 Answers

need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate

0 Answers

For more Instrumentation Interview Questions Click Here