how could you diffrentiate between mild steel and stainless steel by using sin

how could you diffrentiate between mild steel and stainless
steel by using single object. both appears same.

Question Posted / patel.nirav1193

4 Answers
10527 Views
L&T, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how could you diffrentiate between mild steel and stainless steel by using single object. both app..

Answer / guest

mild steel has high dense and rough, but stainless steel has
low dense and smooth.

Is This Answer Correct ?

48 Yes

4 No

how could you diffrentiate between mild steel and stainless steel by using single object. both app..

Answer / rakesh panchal

mild steel have 1% nickle and stainless steel have up to 2%
nickle.
or
by using one drilling process m.s should be soft during
drilling , s.s should be hard during drilling process.( m.s
take less time again s.s drilling process )

Is This Answer Correct ?

11 Yes

0 No

how could you diffrentiate between mild steel and stainless steel by using single object. both app..

Answer / shreedhar

Mild steel can corrode whereas stainless steel is protected
from corrosion.Stainless steel is different from mild steel
due to the amount of chromium present. Stainless steel
contains minimum 10.5% to 11% chromium amount by mass

Is This Answer Correct ?

9 Yes

0 No

how could you diffrentiate between mild steel and stainless steel by using single object. both app..

Answer / saran

By means of color, Mild steel looks little brown with
blackish and stainless steel looks light silver color.

Is This Answer Correct ?

3 Yes

15 No

Post New Answer

More Mechanical Engineering Interview Questions

The Length of the Divergent Cone is about 3 to 4 times than that of the Convergent Cone why

2 Answers DELL,

What type of cross-section is usually of a chisel?

0 Answers

present salary with all benefits (ctc) please give breakup it possible ?

0 Answers

in motor graders the radiator fan exhausts air not suck air why ?

4 Answers Aptron, Volvo,

What is the spinning jenny?

0 Answers

Preparation before arriving port?

0 Answers RRB,

What do you understand by fuel cycle in nuclear plants ?

0 Answers

why dont we use the vapour absorption refrigeration system in power palnts

3 Answers

what is the need of rectifire

1 Answers

What is the importance of Prandtl Number in heat transfer?.

0 Answers

wat's differ b/w air cooled and water cooled chillers..?

4 Answers Oracle,

I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????

7 Answers

For more Mechanical Engineering Interview Questions Click Here