HI SIR PLEASE TELL THE DIFFERENCE OF WELDING TRANSFORMER AND WELDING RECTIFI

HI
SIR
PLEASE TELL THE DIFFERENCE OF WELDING TRANSFORMER AND
WELDING RECTIFIER AND WELDING INVERT ER AND WHICH PLACE IS
USED WHICH TYPE

Question Posted / raja

2 Answers
7214 Views
Alstom, SPML, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

HI SIR PLEASE TELL THE DIFFERENCE OF WELDING TRANSFORMER AND WELDING RECTIFIER AND WELDING INVER..

Answer / angshuman gogoi

Welding transformers are industry standards for welding.
they r step down transformers. they take 220,440 v & give
40, 50 volts. basically they are tap type, movable core &
movable coil types.
welding rectifiers convert ac current to dc current by
using bridge rectifiers.
welding inverters are modern technologies.welding
generators r bulky because the volume of the iron core used
is dependent upon the input frequency of current ( 50 HZ).
in inverters the input frequency of current is increased to
several thousands of Hz, as a result a core size is
significantly reduced. moreover using a single inverter
almost all types of weldings can be performed which is not
possible in case of welding transformenrs.

Is This Answer Correct ?

7 Yes

1 No

HI SIR PLEASE TELL THE DIFFERENCE OF WELDING TRANSFORMER AND WELDING RECTIFIER AND WELDING INVER..

Answer / angshuman gogoi

in the above answer, i wrongly wrote welding generator
which should be actually welding transformers.

Is This Answer Correct ?

6 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

Give five differences between suction and discharge pipes?

0 Answers Unitech,

If a fixed gear having 200 teeth is in mesh with another gear having 50 teeth.The two gear are connected by an arm.What will be the number of turn made by the smaller gear for one revolution of arm about the center of bigger gear? Any effort is appreciable witha proper logic..

8 Answers

what is the difference between high speed and a low speed turbine and on what parameters we will chose or go for either low speed or high speed turbine...

2 Answers

What is the materials of jib and cotter joints?

0 Answers

which bearing use in lathe spindle

7 Answers Denso, Reliance,

how to calculate bearing pre-load?

0 Answers Ashok Leyland,

When looking at a flanged extension pipe and it is labeled DN20, just what does that mean or intel?

0 Answers

When can we using journal bearing and what is differences in duty between it and friction less bearing ?

2 Answers NOC,

in a pump, impeller wear ring is harder or casing ring? why?