Answer / sandeep patel

if power is export to electricity
board and plant does not have its
any kind of home load such as
steel division, cement division
or sponge iron. then plant is
called IPP

Answer / s.mahendran

If the power produced by many source (coal,bio mass,wind) that is called
indipendant power plant.

Why high pressure turbines are single flow 

3 Answers  

---

A 5A rewirable fuse blows when 9A flows.determine the fusing factor?

1 Answers   Schneider, Student, Tata Power,

---

What happens if air is present in LPH and HPH.

2 Answers  

---

We know primary ,secondary air so, What is the work of Tertiary air in Thermal power plant

2 Answers   NPTI,

---

What happens if lizard comes in a MOCB

1 Answers   ABB, Reliance,

---

Why reheater is not used after IP turbine.

3 Answers   Hindalco, SEC,

---

im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much

0 Answers   Student,

---

Planning Engineer interview model question and answer

1 Answers   Tata Power,

---

why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)

2 Answers  

---

Why we need to maintain furnace and secondary air dp.if it increase or decrease what happens.

1 Answers  

---

What is reheater protection based on what mft will be act on RH protection

2 Answers  

---

transformer shut down process.

0 Answers  

---