Answer / loganathan

Yes we can measure pressure with the help of Differential pressure transmitter,we have to connect the HP side of the transmitter to the process line where we are going to measure the pressure,But only thing is we can measure only up to the range of minimum since Differential pressure transmitter will be in range om mmwc.

Answer / manishahir

we measure pressure using differential pressure transmitter by connect the HP side of the transmitter to the process line and LP side of transmitter should be open in atmospheric.

Answer / dhiru patel

Yes,we can use DP tx for pressure measurement for vacuume pressure(absolute PT) and low gauge pressure measurement.It depends on service,pressure range and diaphragm material.

Answer / ayaz

we know that dp transmitter working principle on pressure difference and in dp type transmitter two ranges URV and LRV
1 LRV is low side value and 2 URV is high side value 
SO only reed high side pressure this is vessel pressure
or connect the hart comminucator and then display the vessel pressure 

Answer / johnan

actually we can use the differential pressure transmitter to measure the flow and level, not the pressure, how, if level, it calculate the difference of high side and low side of the transmitter, then it convert to the level using formula,it is a very long explanation,this is only a laymans term...

what is Automation?

3 Answers  

what is the difference between DELTA-V & FOUNDATION FIELD BUS

4 Answers  

hi all plz tell me difrence between analog or digital load cell.

2 Answers  

How to zero trim the level transmitter by using foundation fieldbus communicator.

2 Answers   Emerson,

what is the difference between venturi and orifice meters?

9 Answers   Medha Servo Drives,

How a pH sensor & analyzer work at waste water treatment plant, whats the principle & science is beyond this,How pH sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in analyzer

1 Answers  

If we increase D what will be the controller action?

2 Answers  

How EMF is generated in Thermocouple

3 Answers  

I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

0 Answers  

how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)

0 Answers   Honeywell,

How to measure Flow of air line,what is the procedure of creating DP in line to measure Flow!

3 Answers  

Flame scanner

1 Answers