Answer / sanjeev baghel

yes we chek the encoder by the help of oscilliscope .

Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu

2 Answers   Siemens,

---

What is loop or pigtail in an impulse line?

8 Answers   Qatar Airlines, Qatar Petroleums,

---

What is instrumentation instrumentation engineering?

0 Answers  

---

How to check electrical health of Vibration probe?

1 Answers   QAFCO,

---

what are the problem's will accure in dcs or plc hadware and what are the solution for it?

2 Answers  

---

An RTD is a_________________________.it works as follows

2 Answers  

---

What is pressure,What is temperature,What is flow,What is level

4 Answers   Keltech, Petrofac,

---

which type signal in & out in dcs

4 Answers  

---

i have height of stem drum level 1000mm.how i calculate the DP transmitter

2 Answers  

---

How to define the size of control valve?

5 Answers  

---

How do you troubleshoot accelerometers used in Vibration monitoring/tripping

1 Answers   Air Liquide,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---