Answer / nirmalyabasu

Shielded cable is basically used for carrying analog signals
( mA or mV continuous signal ) to any controller ( PLC or
DCS etc. ) i.e. its required high accuracy. And we have to
minimize the signal noise creating be any kind of
interference. The shield is used for drain out this kind of
noise via electronic earth pit.

Answer / bhavik .j.sudra

It is any type of cable we used to or communication between
to device or connection .impedancen matching and proper
connection .application :connctor are conncted with cable .

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers  

---

What is three element drum level control system why its better than single element?

0 Answers  

---

What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?

0 Answers  

---

If the on Of the DO module is off in the System cabinet, then what is the Procedure to check weather the Module is working or not.

2 Answers   Honeywell,

---

Is it possible to convert 4 wire transmitter to convert to 2 wire with additional relay.Please send detial with drawing,i will appreciate.

2 Answers  

---

where can i find a flameproof hmi unit?

1 Answers  

---

How hart protocol can be connected with control valves?

0 Answers  

---

How to check electrical health of Vibration probe?

1 Answers   QAFCO,

---

How servomotor controls throttle valve of TURBINE?

0 Answers  

---

Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?

0 Answers  

---

i want use pressure transmitter for flow ,how?

5 Answers   Gasco,

---

in transmiters(rose mount) how to check output 4-20ma ? and input 24v? i need exact explanation?

2 Answers   Adhunik,

---