Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nirmalyabasu
Shielded cable is basically used for carrying analog signals
( mA or mV continuous signal ) to any controller ( PLC or
DCS etc. ) i.e. its required high accuracy. And we have to
minimize the signal noise creating be any kind of
interference. The shield is used for drain out this kind of
noise via electronic earth pit.
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
where cascade loop use ?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
Isometric drawings are generated during _________________ phase of a project
how is work pressure switch& level switch?what is the principle of this?
principle of automatic votage regulator
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
Valve positioner and actuators in detail.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
How it the difference between force balance system and dispalacement balance system?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
what is basic difference between motion balance and force balance in pneumatic instrument?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
