Answer / amit rajak

HVDC actually stands for high voltage direct current.


HIGH VOLTAGE DIRECT CURRENT TRANSMISSION SYSTEM
Transmitting high voltage direct current is more efficient
as compared to high voltage alternating current



transmission system. in this system at generating station
11kv alternating current is generated and stepped up with
the use of power transformer

and then it is converted into direct current with the help
of thyratron a device that converts alternating current
into direct current and than it is fed to the transmission
line.

at the recieving end it is again converted into ac
through rotary converters and then it is stepped down with
the help of suitable tansformers.

and is distributing end

what is the working of air drayar

1 Answers  

---

In Siemens S7-300 PLC, what is funtion and funtion block ? What is the difference between them ? When to use function and when to use function block

2 Answers  

---

Grounding. Dear all at one of my site we checked the amps at the earthing cable to the alternator it was found 125 to 130 A. at the neutal cable in same machine found 146A. in the same plant checked the earthing current on other alternator it was 52A, and neutral 116 A. we are facing problems with our controller and the card was damaged once. can that neutral/GND current be a reason? as there is common grounding for the Alternator,Brkr panel,Transformer?

2 Answers  

---

When star connection of motor is use?

1 Answers  

---

One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers  

---

why fractional pitch winding generally used in alternators?

0 Answers   TATA,

---

am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?

0 Answers   L&T,

---

what is suroounding current of dg set?

1 Answers   Airtel, Sukarma,

---

what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks

0 Answers  

---

I NEED RRB CHENNAI (JE ELECTRICAL) QUESTION PAPER FOR LAST 5 YEAR AND I NEED RRB (JE ELECTRICAL) SYLLABUS.PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in

12 Answers   DFM, Hindustan Unilever Limited, JE, Pace, RRB,

---

basic differance between electrical and electronic.

1 Answers   Jindal,

---

What it indicates by 25/41MVA on transformer?

4 Answers  

---