Answer / sanjib ranjan giri

28.868kw

what are the reasons for overheating in electrical machines?

3 Answers  

---

where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.

1 Answers   IOCL,

---

Why we use Capacitor in Single Phase Induction Motor?

12 Answers   IIT,

---

Is there any local or International standards that prohibit the installation of earthing pit in the planters area where the earthing pit is subject to continues soak in water?

1 Answers  

---

what is the need of reactor in between the transmission line?..like powergrid like that..

5 Answers   Delta Roto Tech,

---

Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega

0 Answers   Classic Infotech,

---

i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers  

---

How to measure size of cable on a given load

0 Answers   Green India Engineering Solutions,

---

What is the meaning of capacity of a 63 Amps TPN MCB? Is it the per phase capacity or the totol capacity?

1 Answers   Mother Dairy,

---

how the 6.6KV motor can be used with 11KV?

2 Answers  

---

A 3 phase motor, 440 voltage, induction motor. If we take out rotor from motor and if we give supply 440 volt to stator then what happens?????

20 Answers  

---

How to work definite,over pluxing,revers power,OSR relay

0 Answers   Ford,

---