Answer / daiwat natu

I m Asking Why It Is So???

Answer / d.ramesh classes

In a series circuit, the current through each of the components is the same, and the voltage across the components is the sum of the voltages across each component. In a parallel circuit, the voltage across each of the components is the same, and the total current is the sum of the currents through each component.

by D.RAMESH CLASSES

Answer / sagar kumar

D.ramesh classes you can't explain this answer.

What is an Isolation Xformer? What is the use of it?

2 Answers  

---

how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?

0 Answers  

---

As per BIS, Earth pit resistence value?

4 Answers  

---

What is dielectric loss?

0 Answers  

---

How the annunciator works ? How to do its wiring

0 Answers   Ford, MSEB,

---

can a generator with 15AH specified battery for starting can be connected to a battery of greater capacity?

2 Answers  

---

Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1.  H1-H2 = H2-H3 H3-H1 2.  H2-H3 = H3-H1 H1-H2 3.  H3-H1 = H1-H2 H2-H3 For the LV side also: 4.  X1-X0 = X2-X0 X3-X0 5.  X2-X0 = X3-X0 X1-X0 6.  X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0  H2-H0  H3-H0    X0-X1  X0-X2  X0-X3 128.0  119.9  7.2      29.2   13.3   15.8 70.7   128.4  59.2     23.4   22.0   3.6 7.2    120.1  128.1    13.4   29.3   15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?

0 Answers  

---

What is the difference between earthing & neutral.

2 Answers  

---

We know that, in case if there is a faulty insulation,or sc, the current is bypassed to earth through the earth wire that has low resistance.Actually, what will happen to that current that flows through gnd?In that case,if we come in contact with that faulty appliance, wont that current flow through us as we form a closed path by standing in gnd?Is grounding a safety measure?

3 Answers  

---

How to Calculate 11 KV Side Cable size of a 250 KVA Oil cooled transformer

2 Answers  

---

why capacitor is placed in fan

4 Answers  

---

How to calculate the value of earth capacitance in a transmission line.

0 Answers  

---