Answer / j.saminathan

soil classification should be necessary because through
that only we can caculate the SBC of soil to desing the
structure

Answer / smarika

Classification of soils is necessary since through it an
approximate, but fairly accurate, idea of the average properties of a soil group or a soil type is
obtainable, which is of great convenience in any routine type of soil engineering project.

Answer / n rajesh guttedar

On soil classification we calculate the s.b.c. of different
soil it helps to structure design.

Answer / raja rammohan nayak

Soil classification is observed to know the soil bearing capacity (SBC) of soil.
SBC is varies due to different types of soil..
There are 3 types of soil I.e..
1-coarse grained soil
2-fine grained soil
3-organic soil...

Answer / mohd. abdul kalam

Soils are mainly classified into 3 types

1. Coarse grained soils - are soils which composed of gravel
and or sands and which contain a wide variety of particles.
These are most suitable for foundations when well drained
and well confined. They are soils with good bearing value.

2. Fine Grained soils - are soils that are Silts and
Clays,Contain smaller particles of silt and clay. These are
suitable for foundations but require compactions

3. Organic soils - are the soils consisting of mainly
organic matter like humus, peat, etc... These are not
suitable for foundations.

How to calculate the length of chairs provided to support the top rebar in concrete foundation

2 Answers   L&T, TCE,

how to calculate shuttering measurement of beam and slab

3 Answers   NCCL,

sir i have 2700sq.ft area.i wish to make a coomercial space including this area.sir what could be the estimated cost of 3 story bulding in varanasi.

2 Answers  

what is the degree of residential building stair case ?

2 Answers  

How to find weight of steel in kg if we know the area which is in m2? Following details are known to us, Area=125m² thk of slab=250mm Steel details:T12@200 PS:considering mesh top and bottom with X and Y direction

0 Answers  

The compressing strength of concrete samples (cubic)

3 Answers  

WHAT IS THE MAIN DIFFERENCE B/W HIGHWAYS AND MOTERWAYS?

0 Answers  

waht is the angle of reposae

2 Answers  

what is a well

0 Answers  

how much distance to provide lap lengths in footings,plinth beams, columns, beams& slabs

9 Answers   NCC,

Hollow block masonry in cement mortar 1:4, 40×20×20cms in superstructure take 10sqm.I want calculation of brick sand

0 Answers  

how much the volume of one packet cement ?

6 Answers