Answer / carl_ellis

When the primary flow element (orifice plate, venturi,
averaging pitot tube) is sized to design conditions, the
result is a DP value corresponding to 100% flow rate. That
value is used to configure the DP transmitter.

For level, measurements are made from the transmitter datum
or installed position to the maximum level, with
compensation for the medium's specific gravity. When remote
seals are used, the specific gravity of the fill fluid is
accounted for in a compensating calculation.

Carl Ellis
Measure First

What is the role of integral in PID controller

3 Answers  

---

Explain Difference between Bech set and operating range of control valve

3 Answers  

---

what is seebeck effect?

7 Answers  

---

In Boiler Drum Level- Level control valve how can it tuning (PID)?

2 Answers  

---

Technician A says the brake warning light is connected into both the parking and service brake systems. Technician B says the brake warning light will come ON only if the service brake system fails. Who is correct?

2 Answers  

---

what's the criteria of using over range protector when installing Pressure Gauge

1 Answers  

---

why we use 24v dc in instrument rahter than 230vac????

4 Answers  

---

what is the usage of QDV & VOLUME BOOSTER

0 Answers   ADMA OPCO,

---

How to Calibrate Transducers? Can you give me a step by ste procedure?

1 Answers  

---

How to calibrate a temperature transmitter & how a Cold junction Compensation will be carried out?

2 Answers   QAFCO,

---

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers   Gasco,

---

How to work temperature gauge?

0 Answers   KJS,

---