Interested to Buy Any Domain ? << Click Here >> for more details...
Why sip ring used in ac motor also why its not used in dc motor?
- 2 Answers
- 7226 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / dj
Actualy for better torque in induction motor we should have high resistance and low inductance but in induction motor we have coil which have high inductance so we give high resistance from rheostat to rotor. And we use slip ring because it is use for rotating device only in ac motor
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
What is thresh hold value of current?
What are the commonly used schemes for the bus zone protection?
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
what causes contact chatter when there is no demand on the air conditioning unit?
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
Why is the frequency not changed during transformation of electrical energy in a transformer?
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
What is the difference between Delta & Wye windings?
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
what is per unit calculation?looking for simple and strong explanation thk u
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
