a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?

2 Answers  

---

Differentiate between PLC, SCADA and DCS systems

1 Answers   Mumias Sugar, SRF, Trimula Industries,

---

Why shield is not connected at both end.

5 Answers  

---

how to calculate signal cable sizing? and multipair cable sizing??explain in brief?

0 Answers  

---

Why the tapping connections are taking above for gas service and below for liquid service?

4 Answers  

---

why we use only 4-20 ma signal as AI and not 0-20 ma?

2 Answers   Honeywell, Oil and Gas Jobs,

---

What is zone,loop/fire alarm system?

0 Answers   Emco,

---

how the arrangement of equipments done in control room

0 Answers  

---

the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove

0 Answers  

---

How can i solve the problem of ROSEMOUNT 5300 guided wave level transmitter of full range? For more clearfication , another guided wave level transmitter VEGA brand have the same problem and i solved it by drain the champer from water and make "false signal suppretion" from transmitter push buttons it's configuration to tell the transmitter to avoid any built-up signal ,,, so my question how can i avoid the problem that rosemount read full range while the champer empty or any other ????

1 Answers  

---

hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v

0 Answers  

---

Hello Friends do you know this answer of this Question? Which color you would use when there is Somthing not correct or need to change In P&ID? i mean color that use for highlight that need to update in P&ID. Yellow Highlighter ? Red color ? Blue Color ? Appreciate for your answer. Thanks Blue Color

2 Answers  

---