Answer / saurav ranjan das

Secondary side of the transformer..

Answer / vinodkumarkkp

Secondary side of transformer to make star connection and get a neutral point

Answer / md

secondary side of distribution transformer(which is delta -star manner)

Answer / k.prakashchandra

For 11V supply , ground is the neutral as the neutral of the power tr at the MUSS is connected to earth

in GEAFOL Cast-Resin trnaformer of 11/.72kv which has tapping of 11550v,11250,11000,10246v in primary side. To obtain 700v. which tapping should be used of HV side as we have 11000v/720v tapping now .

1 Answers  

---

In Power cable specification what is U0/U and Um.

0 Answers  

---

How Can we calculate the rating of a cable?Show the formula?

2 Answers   Jindal,

---

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?

0 Answers  

---

Pls anyone explain me the basics of wiring a house?

3 Answers  

---

what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/

0 Answers  

---

WHAT MEANT BY SEVICE FACTOR?

2 Answers  

---

what is spill current?

4 Answers   Adani, NPCIL,

---

In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?

0 Answers  

---

what is circuit breaker in transfomer and where it used

0 Answers  

---

In response to Mr Bikas. If fault current is 52 kA then what will be the CT specification

1 Answers  

---

Voltage drop is the:(a) Maximum potential(b) Difference in potential between two points(c) Voltage at the end of a circuit(d) Voltage produced by a source

3 Answers  

---