Answer / kj

The hystersis is the difference between the voltage at
which the relay operates at and resets at.

For example the UVR is set to open the contacts at 200
volts and it can be set to close at 211.5 volts (for 230
volt sensing). This would be 5% hystersis setting.

This is to stop the relay switching on and off continuously
when the voltage is around 200 volts.

Answer / k.prakashchandra

It should have given in the manual supplied with the
relay.It seems that it is the setting for % drop in
voltage.It is important to set the time delay also.The delay
should not be less than the time taken by any CB of the
power supply system, to clear the fault to prevent tripping
on under voltage due to temporary fault anywhere in the
supply network

Earth Is a very good conductor or very good insulator.? If a good conductor then why current donot flow through small piece f earth and if a good insulator then why we use it as return path in lines.???

6 Answers   L&T,

---

What do you mean by creepage distance?

4 Answers   Amara Raja,

---

FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?

0 Answers  

---

can we use NPT glands in LT panel

0 Answers  

---

what is meaning of phase angle in two phase.

5 Answers  

---

Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB

0 Answers  

---

Define active filter?

0 Answers  

---

How to calculat the size of copper& aluminium wire ?

5 Answers   Hindalco, IOCL,

---

what is difference between multimeter and transmitter

1 Answers  

---

two way ckt diagram can be drawn by how many ways? give diagram

0 Answers  

---

What type of fittings and electrical accessories can be install in radiation area ?

0 Answers  

---

The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s

0 Answers  

---