Answer / varun

per unit value

Answer / michael

PU = per unit value
it is use for high value of rating
in order to reduce it to smaller
value

Answer / a.p.nanjappa

PU means PER UNIT VALUE.
this is used by protection engineers application.
refer CEGB, ABB,SIEMENS HAND BOOK FOR CALCULATION OF FAULT
CURRENT.

what parameters should we check to reduce the power bill

0 Answers  

---

all electricals questions

2 Answers  

---

why is a earth pit 10 ft usually? And, what should be the distance betweeen two earth pit?

4 Answers  

---

When we use PT in HT Panel why the ratio is 11Kv/√3/110v/√3 please explain briefly with suitable formula?

1 Answers  

---

why there is a 2 slits in three pin's earthing pin?

1 Answers  

---

how to calculate the output power of vfd , please help me.

1 Answers  

---

High Voltage out door substation-annual maintenance, things to be considered

1 Answers  

---

What are the commercial names of overhead conductors used in India?

3 Answers   UPSC,

---

how to reduce disel generator voltage from 410-60 hz to 380v-60hz

1 Answers  

---

Can a generator runs after getting 1st stator earth fault.

0 Answers  

---

dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?

0 Answers  

---

full form of electrical?

0 Answers   CEAT,

---