Answer / bibhas roy

The reasons are
i) To reduce ripples
ii) To have flexibility in design of exciter brreaker by
reducing inductance
iii)smaller size in high frequency
iv)high freq. to obtain the required KVA

Answer / a.p.nanjappa

400HZ IS BETTER FOR ACCURACY THAN 110HZ FOR CONTROL SYSTEM

Answer / a.p.nanjappa

400HZ IS BETTER FOR ACCURACY THAN 110HZ FOR CONTROL SYSTEM

What are difference between earthing switch and earthing truck ? What is the operation philoshopy of earthing truck ? Wht are the component of earthing truck ?

2 Answers   Reliance,

---

What is meant by a stray loss of a induction motor??? What is the equation to find it

0 Answers  

---

how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?

1 Answers   ACC, Bhel,

---

In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.

0 Answers   Saint Gobain,

---

What is Difference Between static & Dynamic Pressure of Fan & Blowers

2 Answers  

---

why our indian system choose the 230 volt for single phase&415 for 3-phase voltage,in forign side 110 volt is used what is the difference

4 Answers   Jindal,

---

why the oscillator doent need the ac voltage??how can it produce the ac voltage by applying the dc voltage only??

2 Answers  

---

what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??

0 Answers  

---

what is the difference between power transformer & distribution transformer and what are their ratings respectively?

4 Answers  

---

can any one explain me the where is the use of plc and scada

4 Answers  

---

how electrical earthing maintenance done in industry?

0 Answers   L&T,

---

i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers  

---