Distinguish between shunt and series field coil constructions.

Question Posted / behera.ramesh

2 Answers
12625 Views
BEL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Distinguish between shunt and series field coil constructions...

Answer / muhammad ali

Shunt field coil more number of turns with smaller cross section
Series field coil Less number of turns with larger cross section

Is This Answer Correct ?

11 Yes

2 No

Distinguish between shunt and series field coil constructions...

Answer / issacsamuel

A shunt generator is a type of direct current electric generator in which field winding and armature winding are connected in parallel, and in which the armature supplies both the load current and the field current. A direct current (DC) generator, not using a permanent magnet, requires a DC field current for exitation.
A field coil is an electro magnet used to generate a magnetic field in an electro-magnetic machine, typically a rotating electrical machine such as a motor or generator. It consists of a coil of wire through which a current flows.

http://usawriters.org

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What is the gain of 1-s/1=s at 1 rad/sec?

3 Answers NPCIL,

what is resistor

9 Answers

What is the electrical difference between Earthing Switch (ES) and Maintenance Earthing Switch (MES)?

1 Answers

what safety use in electrical panel

3 Answers

which is batter in construction job,ELCB or RCCB?

7 Answers HCC,

What is hysteresis losses?

2 Answers GMR,

Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient?

0 Answers

WHAT IS THE DIFFERENCE BETWEEN AN ACB & mccb 7 WHAT IS THE CRITERIA WHEN TO USE WHICH OF THE TWO

0 Answers Jk Tyres,

what is the meaning of neutral displacement ???

0 Answers

how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.

0 Answers OPS,

what is form factor?

3 Answers

How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.

0 Answers

For more Electrical Engineering Interview Questions Click Here