Answer / kalaianbu

when the ac transmision voltage goes above the particular
value,the corona effect will occur. the corresponding value
of voltage is called as critical disruptive voltage.

Answer / thileepan.p

hi,
Actually tat term is calld "crictical distruptive
voltage".it deals with carrona loss.in transmission line if
we allow high ac voltage more than tis "crict distr
voltage" means it ill leads to carrona effect.
reference-BL.Thereja

Answer / v.selvakumar

voltage at which insulation properties will loss is called
disruptive voltage

Answer / chandan jha

It is the minimum phase to neutral voltage at which cornro
occurs.It is multiple of break down strength of air , it is
betbeen two wire hving large potential diffrence and less
spaced apart

vc = g.rlog(d/r)

here vc is C.D.voltage , g is breakdown strength of air , d
is distance betbeen conductors, r is radia of conductor .

Answer / guest

desruptive means the highly tensile strength

pls send me some question and answer for rrb railway interviw related 2010

2 Answers   CEAT, RRB,

in dc machines in the armature nature of power is ac but why we take rasistance instead of impedance?

1 Answers  

how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64

0 Answers   Cadsys,

primery try cell?

0 Answers  

why u r living from presentaly working.

0 Answers  

What is distance protection relay? where & why we use this relay?

2 Answers   Siemens, UltraTech, Voltech,

there is a power transformer 66/11kV in delta-delta connection has 5 feeder coming out from the secondary side. One of the feeder in it normally loaded (loaded than other feeder)and this feeder usually trips with double OCR causing the bank transformer to trip. Now if the load of this feeder is put on other transformer then that no problems occurs on that transformer or the load. However normally all the test(IR, PI, short ckt, open ckt,grounding test and other ) has been conducted for this but evertything transformer..... I am not geting what is the actual problem...

2 Answers  

The speed of a dc motor can be controlled by the variation of 1. armature voltage. 2. field current. 3. armature circuit resistance. 4. angle of brush shift. Which of the statements given above are correct? (a) 1,2 and 3 (b) 2,3 and 4 (c) 1,3 and 4 (d) 1,2 and 4

1 Answers  

What are different types of control systems?

0 Answers  

Witch do depand of Power factor and theory of power factor?

0 Answers  

up to what extwnt of voltage the celing fan works?

3 Answers   ICSA,

What is dynamo function in DG sets and draw block diagram?

0 Answers   KPR Agrochem,