what is the difference between Resistance VS capacitance

Answers were Sorted based on User's Feedback



what is the difference between Resistance VS capacitance..

Answer / arunraj

resistance is the ability of a material to oppose the flow
of electron.
while, capacitance is the ability of the material to store
charge with in it.

Is This Answer Correct ?    12 Yes 0 No

what is the difference between Resistance VS capacitance..

Answer / satheesh kumar g

resistance is the property which opposes the flow of electrons and current directly proportional to the applied voltage and inversely proportional to the resistance at a constant temperature.
capacitance is the property to store the charge

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the maintain in ACB,VCB,MCB,MCCB breakers?

4 Answers   CTS,


In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?

5 Answers  


why servomotor motor? where i apply for best output?

0 Answers  


If we want to change a contactor of faulty one what are the conditions want to fullfil

0 Answers   Qatar Shell,


what is the principle of vvvf drive motor

3 Answers  






What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning

0 Answers  


How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.

0 Answers  


temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%

0 Answers  


what is the full form of ka (100A mccb KA)

1 Answers  


What are the various methods for effecive earthing in a factory in a rocky terrain, where soil resistivity is extraordinarily high? The usual method of 3 m deep earth pits is not serving the purpose.

4 Answers  


In A.C systems, fuse is placed in phase-in order to disconnect the circuit during faulty condition. But, what is the reason for putting "LINK" in neutral istead of connecting through (same) wire.

3 Answers  


How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)