Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between Resistance VS capacitance
- 2 Answers
- 5853 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / satheesh kumar g
resistance is the property which opposes the flow of electrons and current directly proportional to the applied voltage and inversely proportional to the resistance at a constant temperature.
capacitance is the property to store the charge
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the feedback in the control system?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
How to operate a ac chilar plant?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
What is the difference between diode and a transistor in terms of the direction of current flow?
Explain cos(theta) and Sin(theta)
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
What is the use of bundle conductors?
Any one can explaination about calibration with rotating sub standards?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What are locations arc protection relay is fixed.
How to back charge the Gas turbine generator
