Answer / yogesh joshi

The IS 456 has given some basic rules to calculate the steel
in beams, colums, foundation, slabs etc in percentage this
can be used as a rule suppose 4% steel can be provided in
coulms and for circuler one provide 6 bars like this we can
get all steel .

Answer / surya v kuchibhotla

It may not be correct to design a structure without having
thorough idea about the behavior of each element in a
structure. Unless we know about various kinds of loads acts
on a structure, transfer of such loads to ground, the
behaviour of natural ground based on its bearing capacity
etc., designing shall not be resorted to. It may lead to a
sudden failure. IS codes will give guidelines. But, their
application shall be made so judiciously.
Books such as Practical designing of RCC structures will
give good guidance in this matter.

What is the roll of face bars in beams

1 Answers  

---

what would be the design load of R.C.C Cooling tower per cell.?

0 Answers   CPMT,

---

Spider cracks occur in beam bottom due to––

0 Answers  

---

how to calculate the bricks in 100yard

2 Answers  

---

what is the approximate density in kg/m3 of compacted hardcore for building foundations

1 Answers   Era Infra Engineering,

---

how much wall area covered by 1 kg of lapi(putty)

2 Answers   Jain Group, Ramky,

---

Construction joint of beam & slab is provided at––

1 Answers   Construction,

---

What is the % steel required for a 3x3 slab.

2 Answers  

---

How much snowcem required per sq. Meter area

3 Answers   Bhushan Power Steel,

---

how to cal 1:4 in brick masonary work cement and sand?

1 Answers  

---

How to find arc area with using angle?with out using angle?

1 Answers  

---

What is Leastcount of 1. Total station 2. Theodolite 3. Dumpy level 4. Plane Table

3 Answers  

---