how to start basic designing in structure..procedure to knw
basic start to do structural designs in civil field?
- 2 Answers
- 4566 Views
- I also Faced
- E-Mail Answers
Answer Posted / yogesh joshi
The IS 456 has given some basic rules to calculate the steel
in beams, colums, foundation, slabs etc in percentage this
can be used as a rule suppose 4% steel can be provided in
coulms and for circuler one provide 6 bars like this we can
get all steel .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
For sloping slabs or sloping beams why the tension steel from either side of ridge is taken into compression zone of other side?
what are the values of compressieve strenght?
what is the sequence of the activities in the typical under ground water tank including civil & MEP works.
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
Explain the design for rcc multi-storied building?
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
What is absolute pressure? How absolute pressure is calculated?
I am doing a engineering contract with GOI. I have purchased certain material from outside Maharashtra and paid CST on that material @ 5.25%. Please intimate whether I will be liable for VAT or VAT on works contract or not.
What is Gsb tollens ?
at which depth the construction of tunnel is economical from cost and engineering aspect.
How to avoid fly ash seed ball formations in the concrete mixer while mixing of raw materials for fly ash block manufacturing?
Why should pumping be not used in case of concreting works?
how to calculate the dry wt of sand and cement for a required design mix?for ex:M20
How you can use different dimension tools in cad? What are the different dimensions available?
cause of cylinder test failure
