Answer / wareagle

You do not have enough information to answer the question.
You did not give the voltage or the load power factor.

Answer / mahendran

185 takes 200amps 2*200=400amps
load factor 75% 400*75%=300amps

you select 185 sq.mm cable 2 runs if the voltage is 415

Answer / mahendran

1 kw = 2 amps ie 148*2=296 amps

240 sq mm will carry 220 amps you make 2 * 240 =480 amps
this is actual amps for safety we give 755 load to the cable so
240*75%=380amps

150sqmmwilltake 180amps ie 2*180=360amps75%load
360*75%=270amps its less then your load

so you can select 2*240 sqmm cables

1.What will be stored in online ups EPROM IC?

0 Answers   IBM,

---

hou we find and calculate the maximum lode capesity of transforer?

1 Answers  

---

what is the opencircuit tes &short circuit test in transformers ,why you need this test, in poen your connecting which votmeter why?

1 Answers  

---

What is the meaning of C1, C61, C91 cable

0 Answers  

---

What is the life of MCCB

1 Answers   Siemens,

---

What are the basic properties of signal flow graph?

0 Answers  

---

Explain cos(theta) and Sin(theta)

0 Answers  

---

what is transient enclosure vltage , very fast transients, very fast transient over voltages

0 Answers  

---

which bridge is used to measure frequency?

2 Answers  

---

in case of OC+EF relay, how the burden is divided/calculated/shared by the CTs in case of normal (healthy condition) and during fault conditions.? three coils of OC & ef coil is conected in residual connection across the three CTS.

1 Answers  

---

hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly

0 Answers  

---

what is the different between bus section and bus coupler

2 Answers  

---