Working principle capacitance type level transmitter

Working principle
capacitance type level
transmitter

Question Posted / sj

3 Answers
8132 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Working principle capacitance type level transmitter..

Answer / sandeep tripathi

c=s/d where s= surface area , d=distance between core &
magnetic field
when level is high then DP is low and when level is low
then DP is high

Is This Answer Correct ?

4 Yes

3 No

Working principle capacitance type level transmitter..

Answer / ramanathan

C=€A/D
Here € is relative permittivity of the material we going to measure
A- area of the probe
D- distance between the probe
here A and D are constant , so change in permittivity is directly proportional to level

Is This Answer Correct ?

0 Yes

0 No

Working principle capacitance type level transmitter..

Answer / nitin ku.sharma

since C=ka/d,here we can't change the area(a) so we are changing (d)the distance between them in order to change the capacitance of the capacitor,thus results in change in voltage and in case of transmitter we get change in currentdue to change in capacitance.

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Instrumentation Interview Questions

what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...

2 Answers

HELLO FRIENDS PLZ EXPLAINE ME WHAT IS ORIFICE?AND HOW WE ARE USING IT IN INSTRUMENTATION

5 Answers Wartsila,

please suggest me, how can i change the display setting in term of unit in place of % of Honeywell pressure transmitter ST3000S100?

2 Answers

WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN

0 Answers

line up procedure for dp type flow transmitter?

0 Answers

what is the difference between sensor and tranducers?

12 Answers

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

1 Answers

typical loop drawing of a simple feedback control comprising of one transmitter and one control

0 Answers

What is minimum distance between three thermocouples (2oo3) mounted on same pipe line (20")? Technically accepted by stright line mounted or circler mounted?

1 Answers

what is wave length were using ?

0 Answers

Single acting ON-OFF valve. it is air to open. when sov energized , valve will be open, so during that if air fail then what will be the condition of valve ( open or close ) ???

4 Answers

What is the difference between radar and ultrasonic level transmitter? Which method is best and more accurate?

8 Answers

For more Instrumentation Interview Questions Click Here