Answer / kj

If due to age or exposure to moisture have caused the
insulation to be lower than normal it can be fixed in most
cases.

The process is to use a solvent which does not harm the
varnish to wash the windings of all dirt. Next bake the
windings in an oven to dry out any moisture. Next
revarnicsh the windings.

Answer / saurabh awasthi

Give 24 V or 110 V DC supply to motor (which is safe for moyor winding) and after few hours IR will improve..

what is the max. acceptable leakage current in 33kv bus bar

0 Answers   Tanesco,

---

why one side of tubelight glows after switch off ?

1 Answers  

---

Is KCL applicable for close circuit?

2 Answers   Toto,

---

What is meant by sotf,lbb,power swing,pole discrepency,auto reclose?

1 Answers   Bunge, Electrical, Omega, TCS, TNEB Tamil Nadu Electricity Board,

---

wil a dc motor run without a starter??

9 Answers   MRF,

---

---

which one has maximum efficiency autotransformer or transformer?? and why??

2 Answers  

---

maximum transmission voltage in india ? & where is it situated ?

7 Answers   GIDC, OPTCL,

---

What is effect of over voltage and under voltage on ACB

0 Answers   EFS,

---

What is the safe limit of voltage between earth and neutral in india.

2 Answers   Incepta Pharmaceuticals,

---

what happens if sf6ckt breaker gas pressure is high or low about the actual rating of gas pressure(5kg/cm2)

2 Answers  

---

Can you explain operating principle of Inverse Definite Minimum Time” (IDMT) relay

2 Answers  

---

wht factor are considered to design ACB( air Circuit reaker) 415V

3 Answers  

---